Focus ST Side Motor Mount Combo
Looking to plant power to the ground, reduce drivetrain slop, drastically lessen wheel hop, all while adding minimal NVH? Look no further, Damond Motorsports has the answer in the DM Side Motor Mount Combo for the Focus ST.
The Damond Motorsports PMM/TMM design:
-The bushings are oriented properly to support the motor and absorb vibrations across the whole bushing.
-This allows us to use stiff bushings without increasing NVH to unbearable levels. Orienting the bushing carrier in a transverse manner further reduces NVH, as less stress is put on bushing flanges.
-Full length welded steel bases, and top PMM/TMM pieces.
-CAD designed, and FEA, and street/track tested. You can't make enough power to break this thing.
-All factory mounting points are retained.
The Damond Motorsports PMM/TMM specs:
-Machined aluminum bushing carrier, anodized gold or black
-Lower mount base and top bases are high strength steel welded, and super thick gloss black powder coating
-All high grade fasteners, and lock nuts
-OTS Energy poly bushings
-Minimal added vibes, along with lots of tire spinning instead of wheel hop.
Easy to install and instructions are published for help. Love the look of them and nice to see a little bit of space freed up. Love the way the car feels and drives. Definitely not for everyone, but I love your products and I’ll keep coming back.
Little harsh until worn in but very good after with less than expected nvh properties! Wish I had purchased sooner! Great traction with these. Stock mounts I had a lot of wheel spin and wheel hop. Gone now
Negated 90% of torque steer. Car absolutely plants power to the wheels. Not hard to install if youre experienced. Vibrations are bad under 2000ish rpms for the first 700 or so miles. Engine lean in the corners is also much lessened. You need these mounts!
Mounts are great, as is the customer service.
DAMOND motor sports have done it again.
10/10 for the Motor and trans mounts solid as a rock
Minimal vibration Crazy smooth gear shifts under load
Once it beds its self in after run in it tames right down
The fitment is exact when lining bolt holes up perfect alignment
Could not be made any better tough as nails
None of that pressed plate going around
All hand built thick plate and great powder coating
If you have increased your power on yourST its a must
best on the market by far